The study area is located in the extreme southwest of the Ougnat Mountains in the eastern Anti-Atlas, which is part of the distorted northern margin of the West African craton. It has Late Neoproterozoic to terminal, Paleozoic and Quaternary lands. In order to obtain a better recognition of the different structural contacts and to define the alignment of mineralized veins in barite and galena at the level of the study area, we used the technique of electrical tomography. The resulting response, in the form of electrical imaging, informed us in detail about the different zones of heterogeneity existing in the prospected soil. In induced polarization, the pseudosections obtained were able to locate the passages of the zones of anomalies encountered and thus confirm their alignments defined by the electrical resistivity measurement results.
The Taroucht area is located south of the town of Tinejdad (southeast of Morocco). It begins with the complete localities of Tin Ayt Mhemd, Ihendar, Taghya, and ends with the great mountainous region which is a part of the great fault which elongates the palaeozoic formations to the town of Banigounssa in the southwest.
In order to obtain a better recognition of the different structural contacts and to define the alignment of the mineralized veins in this zone, we used the geophysical investigation technique.
The measurement procedure consists of the introduction of electrical tomography at the localities of Taroucht and Tabesbaste, whose objective is to highlight an image of the subsoil according to sections of electrical resistivity. In order to confirm the location of the different contacts encountered, we also provided measurements in induced polarization (IP). This imagery gives detailed information on the different heterogeneities existing within the prospected field. The depth of the ground prospected by the measurement profiles is around 54 m approximately. Electrical resistivity tomography is a geophysical tool used in geological, mining prospecting, hydrological, and geotechnical investigations. Resistivity and induced polarization profile lines were carried out with Wenner array. Resistivity and chargeability are well known geophysical methods and are traditionally applied to mineral exploration; see the studies by Bérubé P. [
Given the configuration of the prospected area which is very rugged and given its quality which is strongly fractured, the coupling between these two techniques, electrical resistivity and induced polarization, seems essential. Indeed, the contribution of the chargeability response makes it possible both to confirm the results of the response of the electrical resistivity at the level of the ground prospected and also to distinguish these results from those relating to the clay materials which accumulate in fractures. The fractured zones are the seat of the very frequent flows of water disturbing the exploitation of the deposit in place. In calcareous medium and in sandstone environment, the prospection by chargeability seems better compared to that of the other methods (for example, the electromagnetic technique), and the signal obtained provides contrasts well individualized and easily interpretable at the meeting of the mineralized zones. It should be noted that, for metallic particles, there is a perfect correlation between the response of the resistivity signals and that of the IP signals [
The Ougnat buttonhole is part of the Eastern Anti-Atlas and represents the continuity towards the Northeast of the Saghro Range whose lands are of Neoproterozoic age (Figure
Geological elements of the Anti-Atlas of the East. According to the geological map 1/1,000,000 of Morocco (1985).
The base appears as buttonholes, from west to east, the buttonhole of Saghro and that of Ougnat, with its ENE-WSW orientation. The folding of the palaeozoic cover is enhanced by the formation of the Bani; Ordovician ridge is visible virtually throughout the Anti-Atlas. The large-scale image of the Paleozoic shows a series of domes and basins. It is represented, from West to East, by the basin of Tazzarine and the basins of Maïder and Tafilalet [
The lithostratigraphic series of the study area (Figure
Stratigraphic Log of the study area.
The structuring of this region was carried out in the lower paleozoic and then during the hercynian cycle. It is the hinterland of the hercynian orogeny. Thus, the formations of the study area are characterized by a set of faults of direction generally EW to NE-SW inherited from the rifting periods (Cambro-Ordovician; Devon middle-upper) and which have been reactivated in inversion during the rifting period hercynian orogeny. The corresponding rejections in inversions or inverse weaknesses are at the origin of the generally open folds that occur in the palaeozoic cover of the massif [
General structural scheme of the Eastern Anti-Atlas.
The section of Figure
Synthetic geological section made in the area of Taroucht.
The induced polarization (IP) method is based on a current-stimulated electrical phenomenon observed as a delayed voltage response in earth materials. The IP effect is observed as a residual voltage decay after the current flow is interrupted (time domain IP) or as a frequency-dependent resistivity (frequency domain). In the time domain, the voltage decay is recorded during a time interval Δt = t2-t1 (ms) after the current flow is interrupted. The calculated parameter is the chargeability, given by
The first step in interpreting data in electrical tomography is to construct a pseudosection. This is obtained by plotting the value of the apparent resistivity measured at the center of the array and at a depth dependent on the spacing between the electrodes (Edwards, 1997).
The data was inverted by the Res2Dinv software using the robust inversion L1 [
Implementation of 2D electric tomography (Edwards, 1997).
The acquisition was made by the ABEM Terameter SAS menu of 64 electrodes placed at intervals of 5 m; the length of each profile is 320 m (Figure
Instruments for the measurement of tomography.
In order to obtain a better recognition of the spatial quality of the studied site, we used the technique of electrical tomography, which allows to provide an electrical image of the subsoil, combining both the resistivity response and that of the chargeability based on depth. This electrical imaging provides us with more detailed information on the location of the mineralized zones, on the one hand, and on the determination of the heterogeneity of the ground prospected on the other hand.
Indeed, five profiles in Wenner electric tomography have been realized. Two profiles were made at the sandstone and limestone stromatolite formations of Lower Cambrian age in the western part of Taroucht village, to detect the mineralized barite veins, and the three others are made at the Silurian age shale formations, in the locality of Tabesbaste, whose aim is to follow the alignment of the mineralized veins in galena (Figure
Location of the study area: A, Tabesbaste area; B, Taroucht area.
Profile 1 is executed to the west of the village of Taghoucht, and it is manufactured in the direction of SSE-NNW, in the coordinates of Lambert X = 534792.65m, Y = 86595.67, and Z = 1166m.
The result of this profile (Figure The first zone is located in the SSE part at a distance of 40 m from the beginning of the profile (at a depth of approximately 15 m), its chargeability value exceeds 4 msec, and its resistivity is around 850 Ohm-m. The 2nd vein seems cut by a fracture anomaly. It is close to the surface at the NNW portion and sinks deep in the middle of the pseudosection (about 25 m). Its chargeability is around 2.6 msec and its resistivity exceeds 1600 Ohm-m, and this vein is very thick on the order of 5m in the deep. The passage of another mineralized vein was not detected by the resistivity profile, but it is well evidenced by the chargeability response in the SSE part of the profile.
Inverse model resistivity and chargeability sections (Taroucht 1; direction: SSE-NNW).
The lands that mask the mineralized zone at depth correspond to fissured sandstone formations covered with colluvium accumulating high humidity.
In the middle of the ground prospected, there is the presence of a very wet colluvium accumulation zone; the value of the resistivity is of the order of 60 ohm-m.
It should also be noted that this profile intersects an E-W fracture zone.
Profile 2 was made at a distance of 200 m East of the first profile in direction NNW-SSE and in coordinates Lambert X = 534577.38m, Y = 86442.72m, and Z = 1340 m.
The pseudosections obtained (Figure The first zone is located at about 35 m from the beginning of the ground prospected and corresponds to the passage of a seam flush on the surface and becomes wider and inclined in depth. Its chargeability value is around 5 msec. The second is located almost in the middle of the profile, at a depth of 20 m and chargeability of the order of 2.5 msec. The third zone is marked towards the NNW part at a distance of 240 m from the beginning of the profile. Its depth is almost the same as in the first case and its resistivity exceeds 1500 Ohm-m.
Inverse model resistivity and chargeability sections (Taroucht 2; direction: SSE-NNW).
The orientation of the electrical tomography profiles is selected according to the direction of the vein portions observed at the outcrop. Indeed, according to Figure
Map of correlation of the barite veins obtained by pseudosections 1 and 2(extracted from the Morocco Taroucht geological map 1/50000).
Profile one crosses the two formations (lower Cambrian Asrir sandstone and Neoproterozoic age rhyolitic tuffs). This profile suggests the presence of two veins: the first is located in the southern part and the second at the end of the pseudosection. Profile 2 is made in the sandstone formation, and it shows the presence of the same mineralized veins.
The correlation between the two pseudosections (Figure For the lode identified in the southern part, the response of the chargeability signal is important in rhyolitic formations (2m thick), and this lode sinks deeply in the second profile under the sandstone formations in place which cover both the vein and rhyolitic volcano-sedimentary tuffs. Concerning the vein of the North part, the answer of the chargeability is almost identical in the two pseudosections, and this vein is met with a relatively constant depth (of the order of 20m) and developed on a thickness which reaches 3m.
Indeed, three profiles in electrical tomography have been made in this locality.
Profile 3 (Figure
Inverse model resistivity and chargeability sections (Tabesbaste 1; direction: N-S).
At this locality, the model obtained shows large heterogeneities with significant contrasts, and the values attributed to the passages of the mineralized zones differ considerably from those corresponding to the surrounding lands (shale). Thus, the pseudosection established (Figure
Another relatively mineralized zone is located in the middle of the profile (80 msec). The latter appears cut and associated with a passage of a fracking anomaly zone (direction SSE-NNW), whose resistivity is of the order of 130 ohm-m.
In addition to these zones of anomalies, this profile also shows zones of accumulation of water, and they are located on both sides of the location of the area of fracturing anomaly.
Profile 4 is made in the vicinity of Profile No. 3; it is made in the NNW-SSE direction and Lambert X coordinates = 504294.00m, Y = 96228.38m, and Z = 1173m.
For the resistivity response, the resulting pseudosection (Figure The first is shallow and located in the middle of the profile at a depth of approximately 20 m, but which sinks deeply towards the South-East part. The second zone is also announced in the middle of the profile, but it is deeper. Its summit is close to a depth of about 50 m.
Inverse model resistivity and chargeability sections (Tabesbaste 2; direction: NNW-SSE).
Regarding the chargeability result, we can say that it is a single mineralized passage but well inclined while sinking towards the SE direction. Its load value exceeds 400 msec. The profile announces another deep mineralized zone, but it is less individualized.It should also be noted that this profile intersects a fracture zone clearly visible topographically and oriented slightly N-S.
Profile 5 is made in the N-S direction, in Lambert X coordinates = 504236.30m, Y = 96448.01, and Z = 1161m.
The results of the profile (Figure
Inverse model resistivity and chargeability sections (Tabesbaste 3; direction: N-S).
According to Figure
Map of correlation of the Galena veins obtained by pseudosections 3 and 5 (extracted from the Morocco Taghazout geological map 1/50000).
The correlative study of the profiles carried out suggests the continuity of the vein 3 which becomes more important (3m thick) at the level of the pseudosection 5. Indeed, the general direction of the veins is oriented E-W.
The other two veins identified by Profile 3 are absent in Profile 5; this absence is explained by 2 hypotheses: Their deep penetration, knowing that the pseudosection obtained at their level does not exceed a depth of 26 m The three veins that are joined in Profile 5; that is why one records a thickening of the latter (3 m) and the answer of the signal obtained at its level is relatively more important.
The prospection in electrical tomography carried out at these two localities, Taroucht and Tabesbaste, made it possible to provide information on the different heterogeneities present in the surrounding lands prospected, in this case the Paleozoic formations (sandstone and sandstone limestone). Indeed, it was able to highlight the location and alignment of the mineralized veins.
In the vicinity of the Taroucht area, the comparison between the pseudosection models obtained from the chargeability and those obtained from the resistivity made it possible to locate important zones of anomalies attributed in particular to the location of the baryte veins (BaSO4). Indeed, the passage of the mineralized zones presents important values of the two parameters (resistivity and chargeability); this comes from the fact that the veins are cashed at the level of the most compact parts of the surrounding land; these zones are sometimes raised with respect to the rest. The land seems more altered on both sides of the passage of these veins, sometimes presenting conductive clay intercalations.
It should be noted that the chargeability values obtained at Tabesbaste are higher compared to those obtained at Taroucht; they exceed 100 msec while they are less than 10 msec in Taroucht.
Given the importance of the results obtained in these areas prospected, it is therefore necessary to enrich them by the achievement of other profiles by providing mainly measurements in electromagnetic trails in order to identify the various heterogeneities and their relationship with the veins, on the one hand, and to characterize in a more detailed way their mineral potentiality on the other hand.
The data used to support the findings of this study are available from the corresponding author upon request.
This research did not receive any financial support.
No potential conflicts of interest were reported by the authors.