Rain attenuation at Ka-band is a severe phenomenon that drastically impairs satellite communications at these frequencies. Several adaptive compensation techniques have been elaborated to counteract its effects and most often applied one at a time. The present paper proposes the contemporary exploitation of different techniques in a combined approach. Such an integrated approach is thoroughly analyzed in a simplified scenario and will be shown to achieve a very effective solution, making the Ka-band spectrum fully available for broadband satellite applications and network-centric systems.
The advent of Ka-band (The frequency bands 17.7–21.2 GHz (space to Earth) and 27.5–31 GHz (Earth to space) have been allocated by the International Telecommunication Union (ITU) for the use of Fixed Satellite Services (FSS)) satellite communications is driven by the diffusion of consumer applications (such as High Definition Television broadcasting) and by the increased demand for broadband networks in network-centric systems.
The network-centric architecture, originally conceived for military applications, is becoming a paradigm for large integrated systems, or “systems of systems”, able to collect and to convey data seamlessly throughout a number of different possible media and to deliver useful information after a data fusion process.
Ka-band space segment and ground segment technologies, after a pioneering phase (Italsat [
One the major drawbacks still affecting Ka-band satellite communications is that related to rain attenuation.
Rain attenuation in satellite communication systems operating at Ka-band frequencies is much more severe than that usually experienced at lower frequency bands: rain attenuation at 20 GHz (Ka-band down-link), for instance, is almost three times that at 11 GHz (Ku-band down-link) [
A number of mitigation techniques has been envisioned and experimented over the years, in the attempt to overcome the problem and to make Ka-band satellite applications as commercially viable as those at Ku band [
One first classification of such techniques is between ground-based and space-based solutions.
Ground-based techniques are those basically operated on ground (either in open- or closed-loop configurations) and only indirectly affecting the satellite payload. Among them are Up-Link Power Control (both for transparent and regenerative payloads), End-to-End Power Control (for transparent payloads only), Adaptive Coding and/or Modulation, Site Diversity, and Terrestrial Back-Ups.
Space-based techniques involve, in one way or another, an adaptive use of the payload resources to counteract rain attenuation.
Down-Link Power Control is a technique suitable for both “bent pipe” and regenerative payloads. Adaptive Coding and Adaptive Modulation techniques can be used, in regenerative payload, to adapt the down-link signal characteristics to rain attenuation, independently from the up-link signal.
Adaptive down-link antennas allow a reconfiguration of the gain distribution over the coverage to compensate for higher rain attenuations in specific areas. Contoured beam antennas (in array-fed reflector configurations) can achieve such capability by incorporating variable components (such as variable power dividers) into their beam forming networks.
Active phased-array antennas (either in “array-fed reflector” or in “direct radiating array” configurations) offer an even better control of the down-link EIRP. In an active down-link antenna each radiating element (feed or subarray) is individually fed by a transmit active module (solid-state power amplifier). These antennas not only allow a fast and effective reconfiguration of the gain distribution over the coverage, but also make possible, in case of multiple-beam configurations, a full reallocation of the RF power among the radiated beams. In an active phased-array antenna all active modules (power amplifiers in this case) contribute to the formation of any single beam; this implies that the overall RF power can be dynamically shared among the beams (Power Reconfigurability). On the opposite end, in conventional focused reflector antennas each feed (and its corresponding power amplifier) is virtually associated to only one beam, hence traffic reconfigurability is impossible.
An alternative adaptive antenna configuration is the Multibeam Adaptive Antenna (MAA) concept, which allows a flexible sharing of the total power from the power amplifier modules among the beams by means of a Multiport Power Amplifier (MPA). The application of this antenna configuration to counteract rain attenuation at Ka band was proposed for future generations of Italsat satellites as early as in 1989 [
In particular in the following paragraphs we will focus our attention on the downlink of a multibeam Ka-band system. After a general discussion about individual and joint benefits of Adaptive Coding and Modulation (ACM) and Down-Link Power Control, the proposed integrated approach will be thoroughly analyzed in a simplified scenario.
Adaptive Coding and Modulation (ACM) techniques, applied in interactive and point-to-point applications, provide efficient dynamic link adaptation to propagation conditions, targeting each individual earth station.
The adaptation is obtained by varying the air interface characteristics in terms of modulation constellation and coding scheme. The aim is to allow each user to have a modulation and coding such that at the considered BER the associated required Signal-to-Noise-plus-Interference Ratio (SNIR) is compatible with the experienced atmospheric losses and cochannel interference. It is worth noting that for its efficacy ACM has been selected as baseline for the next generation of the Digital Video Broadcasting via Satellite standard (DVB-S2) [
Link adaptation is achieved informing the satellite up-link station of the channel condition (i.e., SNIR) of each earth station via the satellite return link. Each link operates dynamically exploiting the SNIR to the maximum spectral efficiency. The set of standardized DVB-S2 modes (combination of symbol constellation and coding rates) hinges on the revitalized use of Low Density Parity Check (LDPC) error correction codes initially introduced by Gallager in the 60’s [
The net result is the availability of a fine granularity in the Spectral Efficiency versus SNIR curve (refer to Figure
Spectral efficiency—DVB-S2 versus Shannon’s bound.
Satellite throughput gains of ACM systems have been estimated to reach a capacity increase up to 100%–200% with respect to constant coding and modulation systems (e.g., DVB-S) [
Adaptive coding and modulation techniques allow to effectively comply with different link conditions providing to the users the maximum data-rate permitted with the experienced Signal-to-Noise-plus-Interference Ratio (SNIR). This approach maximizes the individual link exploitation (in terms of spectral efficiency) and the overall system capacity evaluated as sum over all the coverage of active users spectral efficiencies. The availability of a large number of coding and modulation combinations allows to close the link budget in severe interference and fading conditions. The result is an increased link availability at low data rates and a high overall system capacity on a best-effort base. When minimum guaranteed data-rates with certain availabilities are required, the system dimensioning must still rely on power margins on the worst case link budget condition. These power margins, later on, can be fully exploited at operational level to increase the overall capacity on a best effort base.
On the other hand, adaptive power allocation techniques aim at reducing individual power margins by means of an adaptive redistribution of the available RF power based on the real-time needs. The achievement of this objective is strictly dependent on the architecture of the payload high-power section. The idea is to have a common power pool from which a channel can adaptively draw the power it requires. Two candidate solutions are nowadays debated. Flex TWTAs: the power pool is realized at the level of the satellite platform DC power capacity. Each individual TWTA can arbitrarily change (within a range that in current developments is about 3-4 dBs) its saturated RF output power while maintaining a constant efficiency (hence, a DC power consumption proportional to the RF output power) [ Multiport amplifiers: the power pool is realized at RF power level. The sharing flexibility is achieved through the parallel amplification of all signals by a stack of Power Amplifiers [
A joint Adaptive Coding and Modulation (ACM) and Down-Link Power-Control approach can be proven to be advantageous in case a minimum data-rate and an associated availability are required and can be traded off with the overall best-effort system capacity. The approach consists in operating the payload in an RF power-pooled configuration [
To better understand the close relationship between the rain countermeasure on a faded earth station and the remaining population in clear sky we developed a simplified two-cochannel beams model that is reported in the following subparagraphs.
The receiver system temperature can be evaluated as:
The closure of the link budget requires a minimum Signal-to-Noise value that in the following we will consider in terms of symbol energy over noise spectral density:
In a multibeam system with frequency reuse, several beams make use of the same frequency causing cochannel interference that must be duly considered in the link closure condition (
Multibeam antenna geometry ((a) clear sky, (b) fading in Beam-1).
To counteract the fading of
The faded beam output power is increased without changing the power level of the other beams. This can be implemented, for example, increasing the saturation power of a flex TWTA; however, the maximum delta-power is limited by the tube technology. The power increase has two beneficial effects on the faded beam: a compensation of the rain losses and an advantage in terms of Signal-to-Interference. However, an increase of the interference is experienced by the other beams, (refer to (
The overall RF power constitutes a unique pool. An increase of the power dedicated to one beam of an amount equal to
A fair comparison between the two power control approaches with and without power-pooling must take into account that both systems should be dimensioned for the same maximum RF power (or DC power). In this case the power-pooling approach can benefit from a higher clear-sky operating point, equal to the total available RF power divided by the number of active channels/beams (this advantage has been considered in the following graphs).
Consider
Consider
Consider
Consider
Results of the performed analysis are reported in the figures. SNR/SNIR referring to the faded beam are represented in blue, those referring to the clear-sky beam in red.
Examining Figure
Bidimensional link budget analysis (flex TWTAs with linear power control).
Figure
Bidimensional link budget analysis (flex TWTAs with nonlinear power control).
Finally, Figure
Bidimensional link budget analysis (multiport amplifier with nonlinear power control).
The present paper proposed and analyzed the contemporary exploitation of different rain fading countermeasures in a combined approach, based on advanced payload architectures exploiting power-pooling capabilities. Such an integrated approach is thoroughly analyzed in a simplified scenario and it is shown to achieve a very effective solution for the minimum data-rate/availability requirement; at the same time, it preserves the ACM characteristic feature of offering increased capacity on a best-effort basis. The proposed approach makes the Ka-band spectrum fully available for broadband satellite applications and network-centric systems.