Hindawi Publishing Corporation
Research Letters in Optics
Volume 2009 (2009), Article ID 981620
doi:10.1155/2009/981620

Research Letter

Demonstration of an All-Optical 2-to-4 Level Encoder Based on an Optical Parametric Amplifier

Yu Liang, P. C. Chui, and Kenneth Kin-Yip Wong

Department of Electrical and Electronic Engineering, The University of Hong Kong, Pokfulam Road, Hong Kong

Correspondence should be addressed to Yu Liang, yliang@eee.hku.hk

Received 4 December 2008; Accepted 22 January 2009

Recommended by Sulaiman Wadi Harun

We demonstrated a novel technique for all-optical 2-to-4 level amplitude-shift keying (ASK) coding based on a fiber optical parametric amplifier. A 20-Gb/s signal is realized by multiplexing two 10-Gb/s data streams.

Copyright © 2009 Yu Liang et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

1. Introduction

With growing internet, multilevel modulation has received great interest as the increasing demands of the transmission capacity of the optical fiber network while increasing WDM channels is limited by the spectral bandwidth. Multilevel modulation formats are effective ways to overcome such problems because of their higher information packing capacity in a single symbol, that is, coding multiple bits per symbol. Some schemes have been proposed [1–3] to achieve this goal. However, all of these schemes generated multilevel signal electronically, then modulated an optical carrier. Recently, some all-optical methods have been demonstrated to avoid the speed limitation of electronic components. For the multilevel phase-shift keying format, differential quaternary phase-shift keying (DQPSK) and 8-level PSK have been widely studied recently [4]. In order to further increase signal level, simultaneous modulation of amplitude and phase-shift keying (APSK) has been demonstrated [5]. On the other hand, multilevel ASK modulation is also an efficient way to realize higher bit rate in the communication system. Cross-polarization modulation (XPolM) has been explored in semiconductor optical amplifier (SOA) for multilevel modulation implementation [6]. However, this approach requires a dedicated setting polarization-state angle of input waves in SOA.

In this paper, we present experimental demonstration of 4-level ASK at 20 Gb/s using an optical parametric amplifier (OPA). The great triumph of using fiber-based OPA was its inherent femtosecond respond time governed by the nonlinear susceptibility of an optical fiber [7] and potential signal gain. The sole use of OPA effects in our setup makes it a possibility for higher speed operation.

2. Principle

Amongst nonlinear effects induced by nonlinear susceptibility in silica, one of the important phenomena is four-wave mixing (FWM). FWM is also a nonlinear effect that leads to OPA, as a special case of which the waves satisfy the phase matching conditions. In the degenerate FWM case [7], two frequencies of light at and copropagate in a nonlinear medium, then a new frequency component, , can be generated, satisfying . During this process, the interplay between FWM, self-phase modulation (SPM), and cross-phase modulation (XPM) effects can lead to an exponential amplification if is a high-power pump and is a weak probe. This resultant exponential amplification is known as OPA. However, , and are named pump, signal and idler, respectively, as shown in Figure 1. The dashed line represents the gain spectrum of OPA. This optical amplification is achieved by choosing the frequencies of interplaying waves such that they satisfy a phase-matching condition optimal for an exponential gain in power on the signal, and the idler. In the specific case of single pump, OPA occurs at regions satisfying , where , and is the propagation constant as a function of frequency, is the nonlinear coefficient, is the pump power.

Figure 1: Schematic of OPA.

In order to achieve highly efficient OPA, the phase-matching condition should be satisfied by setting appropriate wavelengths of pump and signal. Assuming an undepleted pump, parametric gain , and phase-matching condition is satisfied, can approximately be obtained in decibel as [7] (1) where L is the fiber length. It shows that the parametric gain is exponentially dependent on the pump power.

The principle of the proposed multilevel encoder is shown in Figure 2. Three waves were launched into a spool of highly nonlinear dispersion-shifted fiber (HNL-DSF) as the nonlinear medium. Two of them were amplitude modulated with pseudo-random bit sequence (PRBS) as a pump and probe number 1, respectively. The third one, probe number 2, was a continuous-wave (CW). When the pump and probe number 1 are “0,” only the probe number 2, low CW power comes out, this is the first level. When the pump is “1” and the probe number 1 is “0,” the probe number 2 can be amplified to the second level by OPA process. When the pump is “0” and probe number 1 is “1,” the power comes out from fiber is the sum of probe number 1 and probe number 2 which is higher than the second level and forms the third level. Finally, when the pump and probe number 1 are both “1,” the sum of probe number 1 and probe number 2 can be amplified together, resulting in the strongest power and the fourth level. Then, the two data streams information can be transferred and 4-level ASK encoding was realized through OPA effect.

Figure 2: The operating principle of multilevel encoding.

3. Experimental Setup

Figure 3 shows the experimental setup. The nonlinear medium used for OPA was a spool of 1 km HNL-DSF with nonlinear coefficient  W⁻¹km⁻¹ and zero-dispersion wavelength  nm. The two input 10-Gb/s return-to-zero (RZ) signals were generated by coupling two tunable laser sources, TLS1, with wavelength at 1561 nm and TLS2 with wavelength at 1545.5 nm using a 3-dB coupler. They were launched into two external Mach-Zehnder intensity modulators (MZ-IM) for return-to-zero on-off keying (RZ-OOK) modulation, as pump and probe number 1. The two MZ-IMs were driven by 10-Gb/s 2³¹-1 PRBS and 10 GHz clock, respectively. Then the pump and probe waves were split by a WDM coupler, WDMC1, after amplitude modulation. The pump wave was then amplified to 20.4 dBm by two erbium doped amplifiers, EDFA1 and EDFA2 at EDFA2 output. A 0.8-nm bandwidth tunable band-pass filter, TBPF1, was inserted between two EDFAs to reduce amplified spontaneous emission (ASE) noise at the input of EDFA2. On the other branch, the probe number 1 wave was boosted by EDFA3 to 11 dBm after passing through a 0.8 nm TBPF2 to reduce the noise and optical delay line (ODL) to align the pattern of pump and probe. Then, these two branches were combined by WDMC2. The probe number 2 from the third tunable laser source, TLS3, with input power of HNL-DSF at 0.5 dBm and wavelength at 1545.9 nm, was shifted 0.4 nm from to avoid interference. TLS3 was combined with the output of WDMC2 using a 3-dB coupler and the polarization controller, PC4, was used to adjust state of polarization (SOP) of probe number 2 to obtain maximum gain. The probe number 1 and probe number 2 propagated through the HNL-DSF together to experience OPA effects. The 0.8 nm TBPF3 placed after HNL-DSF, set at 1545.5 nm, was used to filter out the multilevel signal. The TBPF3 output port was monitored by a digital communication analyzer (DCA). The variable optical attenuator (VOA) before DCA was used to prevent damage.

Figure 3: Experimental setup of multilevel encoder.

4. Results and Discussion

The waveforms of coding process are showed in Figure 4, which represent the 4-level data patterns in time domain at 1545.5 nm. According to the encoding principle, the upper and middle patterns are level 1 and level 2 versus level 0, respectively. All 4-level can be identified in the bottom of Figure 4. As demonstrated in Figure 2, the upper pattern was a duplicate of pump pattern. The middle pattern was probe number 1 signal. Then the bottom pattern consisted of the above two. Figure 5 is the corresponding eye diagram. It was found that the level spacing can be arbitrary but we chose around for clear identification [8]. The extinction ratio of the three separated 2-level eye patterns corresponding to level 1, 2, and 3 were 7.56 dB, 11.07 dB, and 13.18 dB, respectively. While the respective signal-to-noise ratios (SNR) were 18.01 dB, 26.31 dB, and 26.56 dB. As the lowest amplitude, the performance of level 1 was relatively weaker than that of the other two due to the existence of the CW. The narrower pulsewidth of levels 1 and 3 whose operation principle was like an AND gate due to pulse compression in FWM process [9]. The mark level of level 3 was noisier than the other levels due to the ASE from EDFA amplified by OPA effect.

Figure 4: The waveforms of 4-level signal. Time base: 200 ps/div.

Figure 5: Eye diagram of 4-level signal. Time base: 50 ps/div.

Furthermore, note that the scheme we proposed here can also be potentially applied to an all-optical digital-to-analog conversion (DAC) system [10]. The incoming serial pulses which represent a digital signal are converted to the parallel pulses by an optical serial-to-parallel converter [11]. The parallel pulses are assigned to the probe and pump as the most significant bit (MSB) and the least significant bit (LSB), respectively. So as indicated in Figure 2, the 2-bit digital signals “00,” “01,” “10”, and “11” correspond to the analog signals “0,” “1,” “2”, and “3”. Consequently, a 2-bit all-optical DAC scheme with binary code can be realized. The advantage of this technique is its easy implementation and flexibility of level spacing optimization.

5. Conclusions

We have experimental demonstrated a novel technique for all-optical 2-to-4 level ASK coding based on OPA. A conversion from two optical RZ-OOK 10-Gb/s signals to a 4-level ASK signal at 20 Gb/s was achieved. The results in this paper have demonstrated that this device has potential usage in improving the performance of the available channel in WDM communication system. Thus, the proposed scheme provides a new way to increase the speed of optical network and meets the growing demand of the internet in future.

The results also exhibit that this device can be applied in all-optical DAC system potentially. This propose is left for future work.

Acknowledgments

The work described in this paper was partially supported by a grant from the Research Grants Council of the Hong Kong Special Administrative Region, China (Projects no. HKU 7172/07E and no. HKU 7179/08E). The authors would also like to acknowledge Sumitomo Electric Industries for providing the HNL-DSF.

References

K. Yonenaga, S. Kuwano, S. Norimatsu, and N. Shibata, “Optical duobinary transmission system with no receiver sensitivity degradation,” Electronics Letters, vol. 31, no. 4, pp. 302–304, 1995.

S. Walklin and J. Conradi, “Multilevel signaling for increasing the reach of 10 Gb/s lightwave systems,” Journal of Lightwave Technology, vol. 17, no. 11, pp. 2235–2248, 1999.

C. H. Kwok and K. K.-Y. Wong, “Phase shifted multilevel amplitude-shift keying for 100 Gb/s ethernet application,” in Proceedings of the Conference on Lasers and Electro-Optics (CLEO '08), San Jose, Calif, USA, May 2008, paper CThH5.

K. Mishina, S. Kitagawa, and A. Maruta, “All-optical modulation format conversion from on-off-keying to multiple-level phase-shift-keying based on nonlinearity in optical fiber,” Optics Express, vol. 15, no. 13, pp. 8444–8453, 2007.

N. Kikuchi, K. Sekine, S. Sasaki, and T. Sugawara, “Study on cross-phase modulation (XPM) effect on amplitude and differentially phase-modulated multilevel signals in DWDM transmission,” IEEE Photonics Technology Letters, vol. 17, no. 7, pp. 1549–1551, 2005.

H. Soto and A. Gutiérrez, “All-optical 2-to-4 level encoder based on cross polarization modulation in a semiconductor optical amplifier utilized to develop an all-optical 2 input digital multiplexer,” Optics Express, vol. 14, no. 20, pp. 9000–9005, 2006.

G. P. Agrawal, Nonlinear Fiber Optics, Academic Press, New York, NY, USA, 3rd edition, 2001.

L. Huo, J. Zhao, C. Lin, C.-K. Chan, and Z. Wang, “Experimental demonstration of a novel all-optical multilevel 4-amplitude-shifted-keying coding/decoding scheme,” in Proceedings of the Optical Fiber Communication Conference (OFC '06), Anaheim, Calif, USA, March 2006, paper JThB41.

H. K. Y. Cheung, R. W. L. Fung, D. M. F. Lai, and K. K.-Y. Wong, “Optical pulse generation using two-stage compression based on optical parametric amplifier,” in Proceedings of the Conference on Lasers and Electro-Optics (CLEO '07), pp. 1–2, Baltimore, Md, USA, May 2007, paper CWB06.

S. Oda and A. Maruta, “All-optical digital-to-analog conversion using nonlinear optical loop mirrors,” IEEE Photonics Technology Letters, vol. 18, no. 5, pp. 703–705, 2006.

M. L. Dennis, W. I. Kaechele, W. K. Burns, T. F. Carruthers, and I. N. Duling III, “Photonic serial-parallel conversion of high-speed OTDM data,” IEEE Photonics Technology Letters, vol. 12, no. 11, pp. 1561–1563, 2000.