Journal of Nanomaterials
Volume 2018 (2018), Article ID 6179492, 1 page
https://doi.org/10.1155/2018/6179492

Erratum

Erratum to “Preparation of Cu₂Sn₃S₇ Thin-Film Using a Three-Step Bake-Sulfurization-Sintering Process and Film Characterization”

Tai-Hsiang Liu,¹ Fei-Yi Hung,¹ Truan-Sheng Lui,¹ and Kuan-Jen Chen²

¹Department of Materials Science and Engineering, National Cheng Kung University, Tainan 701, Taiwan
²The Instrument Center, National Cheng Kung University, Tainan 701, Taiwan

Correspondence should be addressed to Fei-Yi Hung; fyhung@mail.ncku.edu.tw

Received 5 November 2018; Accepted 13 November 2018; Published 13 December 2018

Copyright © 2018 Tai-Hsiang Liu et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

In the article titled “Preparation of Cu₂Sn₃S₇ Thin-Film Using a Three-Step Bake-Sulfurization-Sintering Process and Film Characterization” [1], the name of the first author was given incorrectly as Tai-Hsiang Lui. The author’s name should have been written as Tai-Hsiang Liu. The revised authors’ list is shown above.

References

T.-H. Lui, F.-Y. Hung, T.-S. Lui, and K.-J. Chen, “Preparation of Cu₂Sn₃S₇ thin-film using a three-step bake-sulfurization-sintering process and film characterization,” Journal of Nanomaterials, vol. 2015, Article ID 969783, 7 pages, 2015.