Mathematical Problems in Engineering
Volume 2019 (2019), Article ID 6097095, 6 pages
https://doi.org/10.1155/2019/6097095

Research Article

Modified Adomian Decomposition Method to Solve Generalized Emden–Fowler Systems for Singular IVP

Aisha Abdullah Alderremy,¹ Tarig M. Elzaki,² and Mourad Chamekh2,3

¹Mathematics Department, College of Sciences, King Khalid University, Saudi Arabia
²Mathematics Department, College of Sciences and Arts, AlKamel, University of Jeddah, Saudi Arabia
³University of Tunis El Manar, National Engineering School at Tunis, LAMSIN, 1002, Tunis, Tunisia

Correspondence should be addressed to Mourad Chamekh; chamekhmourad1@gmail.com

Received 15 February 2019; Accepted 1 April 2019; Published 11 April 2019

Academic Editor: Chris Goodrich

Copyright © 2019 Aisha Abdullah Alderremy et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Abstract.

An adeptness modified Adomian decomposition method (MADM) is proposed to solve a generalized system of Emden–Fowler type. By a few examples, it is shown that this method can overcome a singular initial value problem.

1. Introduction

Various methods can be used to approach the analytical solution for nonlinear differential systems, such as the Adomian method [1], the variation iteration method [2], differential transform [3], and novel iterative method [4]. The Adomian decomposition method (ADM) and MADM have made it possible to solve a few ODE problems in the recent years. For this reason, we propose MADM for solving the following system:

where .

This is a generalized system containing the equations which are called Emden–Fowler equations and that would be found in Wong [5]. An equation of this type has been of interest for many searchers in various areas of physics and mathematics because of its deep structure. Examples are as follows: in chemical field, Zhao et al. mention a problem of an autocatalytic chemical reaction [6], Zhai et al propose an application on the elasticity [7], and Li et al. present in [8] a developing model for an enterprise.

As regards the Emden–Fowler systems (EFS), Bidaut-Veron et al. in [9] study an EFS of radial type, dealt specifically with the p-laplacian operator. Böhmer et al. in [10] present an EFS modeling an application for a polytropic perfect fluid.

Here, motivated by the works of Wazwaz [11] where the ADM recommend for getting an analytic solution and Biazard et al. [12] in which the MADM is used, we propose an efficient method to calculate an exact and/or an approximate solution for a larger class of generalized EFS.

This paper is organized as follows. Section 2 contains the proposed MADM for resolving the EFS. A few examples are given in Section 3 followed by a comparison between the exact solutions obtained by MADM and many numerical results are treated in Section 4.

2. Modified Adomian Decomposition Method

The MADM is an excellent technique, which is helping us to take a step forward in the calculus of analytic approximate solutions for various physical problems. We need to solve serious mathematical problems which have not yet has an exact solution. The basic idea of MADM is to consider the nonlinear equation in the formal form:

with and , where is a linear operator and is a nonlinear operator.

The MADM admits the decomposition into an infinite series of components. We assume

and

where are called the Adomian polynomials for all .

In the case of problem (1a), (1b), and (1c), the inverse operator . Applying the inverse operator , on both sides of (1a)-(1b) and considering (4), we get

where and . We note that we have a similar expression obtained from and . We also note that we have intercalating the expression in (5a) similar to (5b), where is an artificial parameter and for all , and are unknown coefficients.

The calculus of the components and , , could be summarized as follows using (5a) and (5b). We can see Adomian et al. in [1] for more details.

We find as follow:

And is given by

For we have

To find the coefficients and , we put ; we immediately verify for all , and in the last, set , to find the solution of problem (1a), (1b), and (1c) in the form

3. Numerical Results

Thanks to precise examples of a singular initial value linear system, nonlinear systems, two unknowns and three unknowns, we can illustrate the suggested method. As well, the system of Emden–Fowler equations is solved to demonstrate the applicability and suppleness of the method for solving even more problems. For simplicity reasons and without limiting the generality of the foregoing, we have considered the initial conditions in all the examples of this paper.

Example 1. First, we aim to illustrate the MADM method by using the following system of linear equations of Emden–Fowler type with and .

To solve this problem by the new method, let us write (10a), (10b), and (10c) using (5a), (5b) as follows:

Using (6a) and (6b) we get

The principle of the MADM is to compute the coefficients and , , by putting and using the expressions (7a) and (7b)

Thus,

And

By equating the coefficients of and setting p=1, we can easily determine and by

(i)To find and

(ii)We have .(iii)To find and

Also we can show that and
From (9a) and (9b) we get the solution of system (10a), (10b), and (10c)

This gives the exact solution of (10a), (10b), and (10c)

Example 2. Consider the cylindrical and spherical equation which is the system of nonlinear Emden–Fowler equations

In the same way as the above example, we substitute the expressions of , , , and in (5a) and (5b). And then we use (6a) and (6b); we obtain

To Find and , , we put and using (7a) and (7b). By equating the coefficients of , we get

and

also , , and .
Then the analytic solution of system (21a), (21b), and (21c) is

Example 3. We can also extend the examples to a system of three unknowns containing linear or nonlinear Emden–Fowler equations. We offer the following system:

Using the same way, we get

Putting and and using (7a) and (7b), we get

also and , and , and .

We verify if , if , and if . This gives the analytic solution of system (26a), (26b), (26c), and (26d) which is given by

This example was also studied by Wazwaz in [13], using the variational method but the solution contained noise terms. The noise terms are a phenomenon which often appears in the system of inhomogeneous equations of Emden–Fowler.

As a result, this proposed method is relatively easy to calculate the coefficients of a system with only two or three unknowns. We can extend this method to a system containing more unknowns, but we need help from symbolic computation Software.

Example 4. Next we study the nonlinear system of Emden–Fowler equations

This system consists of two spherical equations because . To solve this system by the new method, we substitute the expressions of , , , , , and in (5a) and (5b). And then using (6a) and (6b), we obtain

In addition, we also calculate . To Find and , , we put and using (7a) and (7b). By equating the coefficients of , we have

Also we can verify that and . We get the solution of system (30a), (30b), and (30c)

For this system, the exact solution is no longer obvious. To validate the decomposition method, a comparison was made between the MADM method and Adams-Bashforth-Moulton (ABM) method, Table 1. Despite the high performance of ABM method, it cannot solve the EFS on an interval containing zero due to the singularity of the initial conditions. This requires changing the study domain of to . This comparison is made in the neighborhood of zero (see Figure 1) because, usually, the decomposition method gives the solutions in the Taylor series form, at zero.

Table 1: Comparison between MADM and ABM method.

point
ABM method
MADM
error

0,0010
1,0000
0,9999

0,0148
0,9998
0,9998

0,0315
0,9993
0,9993

0,0494
0,9983
0,9983

0,07503
0,9962
0,9962

0,16719
0,9811
0,9815

0,24911
0,9576
0,9596

0,33103
0,9237
0,9300

0,46285
0,8452
0,8688

0,50000
0,8171
0,8491

Figure 1: The solution (u, v) using the MADM and ABM method.

4. Conclusion

In this paper, a new modification of Adomian method was introduced to solve systems of singular initial value problems of Emden–Fowler type of equations with , or . We demonstrate that this method can be well suited to attain analytical solutions by only requiring the calculation of the first Adomian polynomial. The obtained results demonstrate reliability and effectiveness of the employed method.

Data Availability

The data used to support the findings of this study are available from the corresponding author upon request.

Conflicts of Interest

The authors declare that they have no conflicts of interest.

Acknowledgments

The authors extend their appreciation to the Deanship of Scientific Research at King Khalid University for funding this work through Research Groups Program under Grant no. (R.G.P.1 /64 /40).

References

G. Adomian and R. Rach, “Equality of partial solutions in the decomposition method for linear or nonlinear partial differential equations,” Computers & Mathematics with Applications, vol. 19, no. 12, pp. 9–12, 1990.

M. Chamekh and T. M. Elzaki, “Explicit solution for some gen-eralized fluids in laminar flow with slip boundary conditions,” Journal of Mathematics and Computer Science, vol. 18, no. 03, pp. 272–281, 2018.

M. Chamekh, T. M. Elzaki, and N. Brik, “Semi-analytical solution for some proportional delay diferential equations,” SN Applied Sciences, vol. 1, no. 148, 2019.

A. A. Alderremy, T. M. Elzaki, and M. Chamekh, “New transform iterative method for solving some Klein-Gordon equations,” Results in Physics, vol. 10, pp. 655–659, 2018.

J. S. W. Wong, “On the generalized Emden-Fowler equation,” SIAM Review, vol. 17, no. 2, pp. 339–360, 1975.

Y. Zhao, Y. Wang, and J. Shi, “Exact multiplicity of solutions and S-shaped bifurcation curve for a class of semilinear elliptic equations,” Journal of Mathematical Analysis and Applications, vol. 331, no. 1, pp. 263–278, 2007.

C. Zhai and D. R. Anderson, “A sum operator equation and applications to nonlinear elastic beam equations and Lane-Emden-Fowler equations,” Journal of Mathematical Analysis and Applications, vol. 375, no. 2, pp. 388–400, 2011.

M.-R. Li and Y.-L. Chang, “On a particular Emden-Fowler equation u''~u3=0 with non-positive energy-Mathematical model of enterprise competitiveness and performance,” Applied Mathematics Letters, vol. 20, no. 9, pp. 1011–1015, 2007.

M. F. Bidaut-Veron and H. Giacomini, “A new dynamical approach of emden-fowler equations and systems,” Advances in Differential Equations, vol. 15, no. 11-12, pp. 1033–1082, 2010.

C. G. Böhmer and T. Harko, “Nonlinear stability analysis of the emden–fowler equation,” Journal of Nonlinear Mathematical Physics, vol. 17, no. 4, pp. 503–516, 2010.

A.-M. Wazwaz, “Analytical solution for the time-dependent Emden-Fowler type of equations by Adomian decomposition method,” Applied Mathematics and Computation, vol. 166, no. 3, pp. 638–651, 2005.

J. Biazar and K. Hosseini, “A modified Adomian decomposition method for singular initial value Emden-Fowler type equations,” International Journal of Applied Mathematical Research, vol. 5, no. 1, pp. 69–72, 2016.

A.-M. Wazwaz, “The variational iteration method for solving systems of equations of Emden-Fowler type,” International Journal of Computer Mathematics, vol. 88, no. 16, pp. 3406–3415, 2011.