Advances in Materials Science and Engineering

Volume 2012 (2012), Article ID 186948, 2 pages

doi:10.1155/2012/186948

Editorial

Photocatalytic Materials

Guohua Jiang,¹ Tao Chen,² and Qiang Yang³

¹Department of Materials Engineering, College of Materials and Textile, Zhejiang Sci-Tech University, Hangzhou 310018, China

²Division of Polymer and Composite, Ningbo Institute of Materials Technology and Engineering, Chinese Academy of Sciences, Ningbo 315201, China

³Department of Biological Systems Engineering, University of Wisconsin-Madison, Madison 53706, USA

Received 13 December 2012; Accepted 13 December 2012

Copyright © 2012 Guohua Jiang et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

With the rapid development of global industry, steadily worsening environmental pollution and energy shortages have raised awareness of a potential global crisis. So it is urgent to develop a simple and effective method to address these current issues. In recent years, semiconductor photocatalysis has emerged as one of the most promising technologies because it represents an easy way to utilize the energy of either natural sunlight or artificial indoor illumination and is thus abundantly available everywhere in the world. The potential applications of photocatalysis are found mainly in the following fields: (i) photolysis of water to yield hydrogen fuel; (ii) photodecomposition or photooxidization of hazardous substances; (iii) artificial photosynthesis; (iv) photoinduced superhydrophilicity; (v) photoelectrochemical conversion, and so forth [1].

Among various common photocatalysts, bits photocatalytic activity under UVTiO₂ has been extensively used in a wide range of applications (such as gas sensor, solar cell, batteries, etc.), since the discovery of its application in photocatalysis [2]. Since then, intense research has been carried out on TiO₂ photocatalysis, which has been focused on understanding the fundamental principles, enhancing the photocatalytic efficiency, and expanding the scope of applications. Many potential uses of TiO₂ photocatalysis have been identified, such as the hydrogen fuel production, detoxification of effluents, disinfection, superhydrophilic self-cleaning, the elimination of inorganic/organic gaseous pollutants, and the synthesis of organic fuels.

To further improve the photocatalytic performance, there has been great interest in preparation of the supported nanocatalysts, for instance, carbon nanotubes composites, magnetic composites, graphene composites, and so forth, because of their enhanced photocatalytic activity or magnetic separation [3]. Nanomaterials have emerged as pioneering photocatalysts and account for most of the current research in this area. Nanomaterials can provide large surface areas, diverse morphologies, abundant surface states, and easy device modeling, all of which are properties beneficial to photocatalysis. Significant progress has been made in the development of novel nanomaterials in recent years. Nevertheless, the efficiency of nanomaterials, especially in solar photocatalysis, must be improved in order to meet engineering requirements. For example, TiO₂ exhibits photocatalytic activity under UV light ( nm), whose energy exceeds its band gap, resulting in its limited practical applications [4–6]. Therefore, the exploitation of visible-light-driven photocatalysts is indispensable for the practical application of the photocatalytic system. Furthermore, the stability and cost of these materials should also be carefully considered. It is thus a challenge of great importance to identify and design new semiconductor materials that are efficient, stable, and abundant.

Another key issue influencing the photocatalytic capability of a semiconductor is the nature of its surface/interface chemistry. The surface energy and chemisorption properties play crucial roles in the transfer of electrons and energy between substances at the interface, in governing the selectivity, rate, and overpotential of redox reactions on the photocatalyst surface, and in determining the susceptibility of the photocatalyst toward photocorrosion [1]. In general, a higher surface energy yields higher catalytic activity. Recently, much interest has been focused on research into semiconductor crystals with morphologies, such as nanorods, nanoparticles, nanotubes, and micro/nanospheres, which have been fabricated successfully and that provide large percentages of highly reactive facets [7–10]. Appropriate modification of the surface is frequently necessary to facilitate photocatalysis.

Despite important insight being gained, the mechanisms involved in photocatalysis are not yet known in detail. Fulfilling this goal requires the help of theoretical investigations such as electronic structure calculations and molecular dynamic simulations. Indeed, the theoretical study of photocatalysis has progressed rapidly alongside the experimental work. The above computational methods require a degree of understanding of photocatalysis. The calculation results obtained then raise the level of this understanding and provide guidance toward the practical improvement of photocatalytic materials and their applications.

The papers in this special issue concern the development of new photocatalytic nanomaterials for degradation of organic pollutes. They concentrate on preparation of photocatalytic materials, with assistant of magnetic nanoparticles, metal or nonmetal doping, annealing treatment. Novel photocatalytic materials or special preparation process are provided to solve limited photocatalytic activity that hindered by the lack of visible absorption. The works assembled in the present volume contribute to such development. Hopefully, they will inspire further research along the same lines.

Acknowledgments

We would like to thank all authors who have submitted their manuscripts to this special issue and the following external reviewers for their invaluable contributions to the reviewing process: Haojie Yu, Wenqin Wang, Jiaguo Yu, Yin Wang, Xinke Sun, Panayota G. Vassiliou, Jia Huo. We would like to thank Hindawi Publishing Corporation for giving us this great opportunity of organizing this special issue.

Guohua Jiang

Tao Chen

Qiang Yang

References

H. Tong, S. Ouyang, Y. Bi, N. Umezawa, M. Oshikiri, and J. Ye, “Nano-photocatalytic materials: possibilities and challenges,” Advanced Materials, vol. 24, pp. 229–251, 2012.

A. Fujishima and K. Honda, “Electrochemical photolysis of water at a semiconductor electrode,” Nature, vol. 238, no. 5358, pp. 37–38, 1972.

R. Wang, G. Jiang, Y. Ding, et al., “Photocatalytic activity of heterostructures based on TiO₂ and halloysite nanotubes,” ACS Applied Materials & Interfaces, vol. 3, pp. 4154–4158, 2011.

S. Yin, B. Liu, P. Zhang, T. Morikawa, K. I. Yamanaka, and T. Sato, “Photocatalytic oxidation of NOx under visible led light irradiation over nitrogen-doped titania particles with iron or platinum loading,” Journal of Physical Chemistry C, vol. 112, no. 32, pp. 12425–12431, 2008.

Y. Ide, M. Matsuoka, and M. Ogawa, “Efficient visible-light-induced photocatalytic activity on gold-nanoparticle-supported layered titanate,” Journal of the American Chemical Society, vol. 132, no. 47, pp. 16762–16764, 2010.

G. Jiang, R. Wang, H. Jin et al., “Preparation of Cu₂O/TiO₂ composite porous carbon microspheres as efficient visible light-responsive photocatalysts,” Powder Technology, vol. 212, no. 1, pp. 284–288, 2011.

G. Jiang, X. Wang, Y. Zhou, et al., “Hollow TiO₂ nanocages with Rubik-like structure for high-performance photocatalysts,” Materials Letters, vol. 89, pp. 59–62, 2012.

G. Jiang, R. Wang, X. Wang, et al., “Novel highly active visible-light-induced photocatalysts based on BiOBr with Ti doping and Ag decorating,” ACS Applied Materials & Interfaces, vol. 4, pp. 4440–4444, 2012.

D. Jian, P. X. Gao, W. Cai et al., “Synthesis, characterization, and photocatalytic properties of ZnO/(La,Sr)CoO₃ composite nanorod arrays,” Journal of Materials Chemistry, vol. 19, no. 7, pp. 970–975, 2009.

J. Huang, K. Ding, Y. Hou, X. Wang, and X. Fu, “Synthesis and photocatalytic activity of Zn₂GeO₄ nanorods for the degradation of organic pollutants in water,” ChemSusChem, vol. 1, no. 12, pp. 1011–1019, 2008.