Verification of Xiphoid Point as a New Measuring Point for Chest Shape Measurement

The measurement point of chest shape based on non-rigorous ergonomics is the key problem affecting the accuracy of measurement results. Xiphoid point, as a representative human skeleton point, can provide a theoretical basis for the development of new chest shape measurement methods and technology. In order to verify the stability of xiphoid point, 30 subjects were selected to measure the chest shape based on upper limb movement in the transverse plane of human body. The displacement of mastoid and xiphoid points in the sagittal plane, coronal plane, and axial plane was compared, and the factors influencing the displacement of mastoid and xiphoid points were analyzed. The results showed that the displacement of the mammary point was the largest in the coronal plane during the upper limb movement. The displacement of xiphoid point is far less than that of mastoid point. The displacement of the breast point is closely related to the chest circumference when the upper limb is in the horizontal adduction. There was a positive correlation between the displacement of xiphoid point and the amplitude of upper limb movement. Compared with mammary point, xiphoid point is a fixed and stable measurement point of chest shape.


Introduction
Adolescence is a critical period of female breast development. Appropriate bra products play a key role in the physical health of their cardiopulmonary activities and the mental health of peer communication [1]. However, relevant literature points out that 80%-85% of girls choose inappropriate underwear [2]. rough actual interviews and analysis of the status quo of girls' underwear patents and commodities, it is found that between the unprotected waistcoat circumference and the adult bra, there is not only a lack of supplies needed to protect and accompany the growth of girls but also a lack of measurement technologies and methods and tools for the appropriate selection of products. e key lies in the most fundamental problem of the measurement point of breast shape, that is, unstable breast spot and approximate upper and lower chest circumference [3].
In ergonomics, in order to obtain the correct human body size, the necessary measurement base points are marked on the human body before measurement to indicate the correct measurement position [4]. e measurement base points usually take the protrusions of bones, joint ends, cutting marks, and sutures that can be obtained from the touch of the skin surface as the measurement basis [5][6][7]. e position of the measurement points is wrong, and the data of the test samples are suspicious or even wrong.
To sum up, the reasonable, accurate, and ergonomic measurement base point should be the human skeleton point, which has the characteristics of representativeness and stability. However, according to the description of human anatomy, the breast is the only female organ without bone support, and the interior is mainly gland, breast lobule, and adipose tissue [8][9][10][11][12]. Due to the particularity of breast tissue, breast points or human surface feature points are often extracted as the measurement points of breast shape measurement rather than the bone base points [9]. Breast point and feature point are not fixed bone points, so they are not suitable human factor measurement base points and do not conform to the basic principles of measurement [13]. In addition, it is easy to displace the breast point due to its own action or the compression of the measuring tool makes the breast deform or change the curvature, resulting in measurement errors and affecting the accuracy of chest measurement [14][15][16][17].
e breast needs to be protected and supported during the development of girls. e stable bone can be used as a fulcrum to exert force, so that the bra can stabilize the vibration of the chest [18]. e xiphoid point is located at the sternoclavicular joint, in the center of the human body, and easy to touch, so it is representative. In order to verify whether the xiphoid point conforms to the theoretical characteristics of the stability of the measuring point in ergonomics, this paper aims to compare and analyze the displacement of the xiphoid point and the breast point during the upper limb movement, so as to prove the progress of the xiphoid point as a new chest shape measuring point. It lays the foundation for the following new chest measurement methods and measurement technologies and makes the bra industry have innovative development.

Participant.
irty women volunteered to participate in the experiment, and none of them were pregnant or breastfeeding. As shown in Tables 1 and 2, the age, breast size, and physical characteristics of participants vary. e breast size of each participant is classified according to the existing underwear model classification method, which is based on the difference between the upper chest circumference and the lower chest circumference [19]. e purpose of the experiment is to test the stability of the new measuring point, that is, to compare the displacement of the breast point and the xiphoid point during self-measurement with the displacement of the three upper limb states of the human body and their influencing factors.

Participant.
e breast is a three-dimensional organ. One camera cannot capture the displacement of the human body in three axes. erefore, three Canon EOS 800D digital cameras (24.2 million effective pixels, 128G SD card) are used to record the activities of the breast in three angles of the upper limb. e three digital cameras were fixed at 0.9m from the front, left, and top of the subject. All three cameras were fixed with T-170 SLR tripods, and the focal length of the camera was adjusted with the main target in mind, so the lens needed to be adjusted at the same height as the nipple to capture the displacement of the nipple point and the new measurement point in three directions. e experiment was completed in the laboratory where the room temperature was (25 ± 2)°C, the relative humidity was (65 ± 5)%, and the wind speed was less than 0.1 m/s, which ensured the stability of the experimental results. During the experiment, the electric lights were fully turned on to obtain sufficient lighting.

Test Displacement Action.
As for the selection of test movements, the upper limb activity is mainly the movement of shoulder joint, which is a complex structure composed of sternoclavicular joint, clavicle, acromioclavicular joint, scapula, glenohumeral joint, proximal humerus, and scapular chest wall joint. e movement of the acromioclavicular joint may include the movement of the clavicle relative to the scapula in three directions, namely, the abduction of the coronal axis, the anterior and posterior lifting of the sagittal axis, and the adduction and extension of the transverse axis. Among them, the range of motion of the sagittal axis is about 120°-180°, and the range of motion of the sagittal axis is about 40°-60°. e range of abduction motion of the coronal axis is 0°-180°. e range of adduction motion of the transverse axis is about 0°-135°, and the range of extension motion is about 0°-30°. As shown in Figure 1, in the milk point displacement test, the maximum range of motion of the coronal axis, the sagittal axis, and the transverse axis is selected, respectively, that is, the abduction of the coronal axis is 90°(recorded as CP1) and 180°(recorded as CP2), the elevation of the sagittal axis is 90°(recorded as SP1) and 60°( recorded as SP2), and the adduction of the transverse axis is 135°(recorded as TP1) and the extension of the transverse axis is 30°(recorded as TP2). According to the classification of joint anatomy, joints are divided into immobile joints, inching joints, and moving joints. e xiphoid point on the sternum belongs to immobile joints and is stable, but the skin covering the xiphoid point will also shift due to the influence of upper limb movement, thus affecting the accuracy of chest shape measurement. erefore, in the selection of xiphoid point displacement measurement action, the 90°abduction (CP3) and 180°abduction (CP4) of the coronal axis with the greatest displacement effect were selected.

Experimental Procedure.
Before the test, the subjects need to bare their upper body, expose the umbilicus, and cover their hair with a mesh headgear after the messenger's hair is tied up as required.
e test position is upright sitting position, which can reduce the involuntary shaking of the human body. e subjects' eyes look straight ahead, the left and right thighs are roughly parallel, the knees are bent roughly at a right angle, and the feet are flat on the ground. Before measurement, use a marker to mark the   Figure 2, the geodetic coordinate system is established before the displacement results are measured. e umbilicus point is less affected by the activities of the upper limbs, so it is selected as the origin O. e coronal section of the human body is taken as the X axis, the direction of the x-axis is positive forward, the sagittal section is taken as the Y axis, the direction of the y-axis is positive leftward, the transverse section is the Zaxis, and the direction of the z-axis is positive upward. e displacement is measured by CorelDRAW 2019 computer software. e purpose of using this software is to have the function of measuring tool, which can mark the size of objects and the distance between objects. When measuring, turn on the snap function in the function list, select the snap object and dynamic auxiliary line, and assist in the alignment and selection of measurement in this study. In this study, the measurement style is decimal, the measurement accuracy is two decimal places, and the measurement unit is mm.

Statistical Analysis.
e displacement of the breast point in the sagittal, coronal, and transverse planes of the human body and their respective x-axis, y-axis, and z-axis when performing the six actions of 90°forward lift and 60°b ackward lift, 135°inward retraction and 30°outward extension, and 90°outward abduction and 180°is compared with the displacement of the new measuring point in the coronal z-axis when performing the two actions of 90°o utward abduction and 180°through descriptive statistics such as minimum value, maximum value, mean value, and standard deviation, so as to know the direction and axial direction of the maximum displacement.
In order to analyze the factors affecting the breast point and the new measuring point except for the upper limb movements, the Pearson correlation between the breast point and the new measuring point and the test value sig with significant difference were tested. e statistical significance was compared with 0.05 and 0.01. If it was greater than 0.05 or 0.01, the difference was significant. All analyses were performed using SPSS 25. Figure 3 shows the displacement of the two breast points of 30 subjects when they perform the test actions of 90°front and 60°back lifting of the upper limbs in the sagittal plane. Table 3 shows the descriptive statistics (minimum, maximum, mean, and standard deviation) of the breast point raised 90°in front of the sagittal plane and 60°behind the sagittal plane. e results showed that the displacement of the y-axis, i.e. the left and right directions, was significantly greater than that of the other axes (18.79 ± 1.77) when the upper limb was lifted 90°b efore the test, and the largest displacement was also the yaxis (17.35 ± 2.33) when the upper limb was lifted 60°after the test. e displacement of the breast point of the x-axis Computational Intelligence and Neuroscience was the least in the sagittal plane, which was 2.95 ± 1.15 and 7.94 ± 1.45, respectively. Figure 4 shows the displacement of the two breast points of 30 subjects when they perform the upper limb internal 135°and external 30°test actions on the transverse plane. Table 4 shows the descriptive statistics (minimum value, maximum value, mean value, and standard deviation) of milk points at 135°adduction and 30°extension, respectively, on the transverse plane. e results showed that the displacement of the y-axis, i.e. the left and right directions, was   significantly greater than that of the other axes (24.69 ± 3.09) when the upper limb was retracted at 135°, the largest displacement was also the y-axis (26.42 ± 2.95) when the upper limb was extended at 30°, the displacement of the breast point of the upper limb at 135°retracted at the x-axis was the least (4.45 ± 0.98) in the sagittal plane, and the displacement of the z-axis at 30°was the least (6.41 ± 1.50). Figure 5 shows the displacement of two breast points of 30 subjects when performing 90°and 180°upper limb abduction tests on the coronal plane. Table 5 shows the descriptive statistics (minimum value, maximum value, mean value, and standard deviation) of 90°and 180°abduction of milk points on the transverse plane, respectively. e results showed that when performing 90°and 180°abduction of the upper limb, the displacement of the z-axis, i.e. the up-down direction, was significantly greater than that of the other axes, 29.21 ± 2.17 and 47.31 ± 4.86, respectively. e displacement of the breast point of the coronal upper limb movement in the y-axis was the least, 6.39 ± 1.45 and 1.06 ± 0.64, respectively.

Nipple Displacement Analysis.
As shown in Table 6, during the comparative analysis of the breast point on the three sides of the human body during the upper limb movement, it can be seen that the displacement of the breast point in the coronal plane, i.e. the fore-and-aft direction, is the largest, 47.99 ± 4.78 and 31.20 ± 2.27, respectively, while the displacement of the     Table 7, there is a weak correlation between the displacement of breast points in each axis between the faces when performing upper limb movements, while the horizontal plane, i.e., 135°adduction in the up and down direction, has a significant correlation with the chest circumference at the level of 0.05, and the displacement caused by other movements has no significant relationship with the     Figure 6 shows the displacement of each new measuring point of 30 subjects when performing 90°and 180°upper limb abduction tests on the coronal plane. Table 8 lists the descriptive statistics (minimum value, maximum value, mean value, and standard deviation) of the xiphoid points at 90°and 180°abduction, respectively, in the transverse plane. e results showed that the displacement of the new measuring point at 180°abduction was greater than that at 90°abduction.
As shown in Table 9, the displacement caused by 90°a bduction of the upper limb in the coronal plane and 180°a bduction is highly correlated at the level of 0.01, and the displacement is positively correlated with the action amplitude of the upper limb in the coronal axis, but not with BMI, chest circumference, and lower chest circumference.

Comparative Analysis of Displacement between Breast
Point and Xiphoid Process. Table 10 provides descriptive statistical information (mean value, range, and standard deviation) by comparing the displacement of the breast point in the sagittal, transverse, and coronal planes and the displacement of the xiphoid point in the coronal plane. e mean value of the displacement of the breast point in the coronal plane is the largest (31.2 ± 12.21 and 47.99 ± 25.76, respectively), and the mean value of the displacement of the xiphoid point is significantly smaller than that of the breast point in the coronal plane (2.41 ± 4.68 and 4.79 ± 13.52, respectively), with high reliability. e displacement range of breast point was the largest when performing coronal plane motion. erefore, the stability of xiphoid point is higher than that of mammary point.

Conclusion
In order to verify the stability of xiphoid point as the measuring point of new chest shape, the movement displacement comparison experiment of breast point and xiphoid point was carried out. rough the experiment, it is found that the breast point, as the measuring point of the chest shape, will have a great displacement during the movement of the shoulder joint of the upper limb, which will affect the accuracy of the measurement. Although the xiphoid point has a certain offset due to the attached skin, the overall displacement is far less than that of the breast point, which is less affected by the upper limb movements. It is a progressive chest measurement point, which provides a reference for the innovation and development of chest measurement technology.
In the follow-up research work, based on the new chest measurement point, i.e., xiphoid point, the linear dimension, angular dimension, body surface dimension, concave convex curvature, volume, and other derived dimensions of the breast can be measured to reflect the overall picture of the chest, so as to construct a chest measurement method and measurement tool with high accuracy.
Data Availability e dataset can be accessed upon request.

Conflicts of Interest
e authors declare that they have no conflicts of interest.